To ensure you order the correct size of ring please follow the guidelines below. We do not offer free resizings or remakes, so be sure you order the correct size! Because each ring is a custom commissioned piece we do not offer refunds. Before ordering, we recommend getting sized by two or three reputable jewelers following our guidelines below for wide and thin rings. Because our finger sizes can fluctuate a bit during the day depending on how hot or cold we are, it’s also not a bad idea to get sized at different times of the day.
WIDER RINGS (6mm-10mm wide): We recommend being sized using STANDARD FIT rings (not comfort fit) that are WIDE (at least 6mm) as the ring you would like to order from us. Most of our men's rings default to 8mm wide. Please do not use the thin sizing rings that jewelers have as these are not accurate and an actual ring will be tighter (because of added width) than the sizing rings that are used. If possible, get the millimeter measurement of the inside diameter of the ring that fits with a digital caliper. This will always be the most accurate way for us to size rings.
While we use our own method to create comfort of wear on our rings it is is different than what is referred to as "comfort fit" at most jewelry stores. For this reason, try on standard fit rings. We provide a beveled-cut edge and will thus be more comfortable to the wearer than a typical standard fit ring. Lastly, do not allow a jeweler to give you a size according to a ‘ring-sizing dowel’, as in our experience with the dozen or so dowels we have in our own shop they all measure differently and can vary based on how the jeweler was trained to read it. A ring can be off by a half size or more, depending on the dowel.
THINNER RINGS (1mm-5mm wide): We recommend being sized using rings that are the same width as the ring you will be ordering in, if at all possible. If a matching width is not available at the jewelers we have also found that the thin key ring sizers are accurate for rings made in a 1mm-5mm width. Do not allow a jeweler to give you a size according to a ‘ring-sizing dowel’, as in our experience with the dozen or so dowels we have in our own shop they all measure differently and can vary based on how the jeweler was trained to read it. A ring can be off by a half size or more depending on the dowel.
If you have any questions about sizing you can always shoot us an email and we will do our best to answer your questions!
Please note that our rings are true to international sizing standards, and our acceptable tolerance on every ring is +/- a tenth of a millimeter.
Rings ordered in size 13 or larger are subject to a increased material fee starting at $30 in titanium. Rings ordered wider than 8mm will be subject to a similar charge.